General Articles

How To Change An iPhone Battery

Along with cracked screens and freezing hard drives, battery life is among the very best items inside your mobile Apple handheld product like an iPhone, iPod, or iPad. While there are multiple settings in your iPhone that increase battery life, after your battery is dead, it then becomes an expensive paperweight. If you are ready to undertake the challenge of changing the battery, then follow the actions outlined below.

The tool you’ll have to take on replace your iPhone battery include a specially made screwdriver known as a Screw Driver Torx kit. Additionally, you’ll require a replacement battery. Both of them are offered at numerous online retailers. Now let’s begin in the repair procedure.

The first step in removing an iPhone battery would be to insert the pointy end of a safety pin to the small hole near the headphone jack. This will eject the tray section of the rear plate. Then remove the two screws on either side of the pier end. You would like to now separate front screen from the rear panel by wedging the spudger between the glass front panel and chrome ring. Always take care not to tear any ribbons which still connect both panels. The previous ribbon cable can be published by turning up the white tab in place. This will allow the front and rear cases to become completely different. Then remove the eight screws holding the motherboard down. A ribbon visiting the camera will still attach it. Remove that specific ribbon in the camera to set the motherboard aside. Pry out the camera to permit the logic board to slide out. Ensure all screws securing the logic board are eliminated before doing this.

Does iPhone battery replacement seem too complex? It will tend to be for many novices. Just do not forget that there are a whole lot of small parts on your device and extreme care must be used not to lose them.…